16
2 Pour the rinse aid into the dispenser but be careful not to overfill.
3 Replace the cap by inserting it aligned with the “open” arrow and turn
it in the direction of the “closed” arrow (right).
This dishwasher is designed to use liquid rinse aids, and the rinse aid
dispenser is located inside the door next to the detergent dispenser.
The rinse aid is released during the final rinse to prevent water from
forming droplets, which can leave spots and streaks on your dishes. It
also improves drying by allowing water to sheet o the dishes.
To fill the dispenser, open the cap and pour the rinse aid into the
dispenser until the level indicator goes completely o. Please be
aware that the volume of the rinse aid container is about 140 mL,
so please be careful not to overfill the dispenser as this could cause
over spilling. Wipe away any spills with a damp cloth. Do not forget to
reinsert the cap before you close the dishwasher’s door.
Attention!
Clean up any rinse aid spilled during filling with an absorbent cloth to
avoid excess foaming during the next wash.
Adjusting Rinse Aid Dispenser
Adjust lever
(Rinse)
The rinse aid dispenser has four or six settings,
but it is recommended to always start with the
dispenser set on “4”. If spots and poor drying
are a problem, increase the amount of rinse aid
dispensed by removing the dispenser lid and
rotating the dial to “5”. If the dishes still do not dry
properly or have spots, adjust the dial to the next
higher number until they are spot-free. The dose
is factory set in the position 5.
NOTE: Increase the dose if there are drops of water or lime spots on
the dishes after washing. Reduce it if there are sticky whitish streaks on
the dishes or a bluish film on glassware or knife blades.
AF MANUAL MÁQ. LOIÇA ENCASTRE BBIDW5370 A5 (2).indd 16AF MANUAL MÁQ. LOIÇA ENCASTRE BBIDW5370 A5 (2).indd 16 08/09/2020 12:0908/09/2020 12:09