16
142 x 208 mm
Cleaning the dust container
1. Make sure that the appliance is switched off and is not on charge.
2. Empty the dust container (see above).
3. Remove the dust container. The dust container ap must be closed. Hold the front end of the dust container, press rmly
with your thumb where the red sticker is and pull downwards (see Figure III).
4. Dismantle all 4 parts of the dust container. In order to do this, remove the motor pre-lter (see Figure V). Take out the
dust container insert. Loosen the lter screen by rotating the bottom section of the dust container insert.
5. Remove any dirt from all of the parts.
Note: All parts and the lter may be wet cleaned. In this regard, it is imperative to ensure that all parts are fully
dry before the appliance is used again. It takes approximately 3 days for the lter to dry. If necessary, use the
replacement lter provided during this time.
6. After drying completely, insert the lter screen into the dust container insert and rotate it to lock it into place.
7. Place the insert into the dust container (the openings on the dust container and the insert must be lined up).
8. Position the motor pre-lter (foam side downwards, white side with grip upwards).
9. Install the dust container on the device (see Figure IV).
Maintaining the appliance
Cleaning the brush roller
Soiling may prevent the brush roller from rotating freely. Clean the brush roller regularly.
1. Make sure that the appliance is switched off and is not on charge.
2. Disconnect the oor nozzle from the suction tube.
3. Loosen the brush roller locking device from the side of the oor tool, using a coin if necessary.
4. Gently push the brush roller out to the side.
Attention! Risk of injury due to sharp inner edge.
5. Remove any hair and dirt from the brush, using a pair of tweezers or scissors carefully, if necessary.
6. Fit the brush back onto the oor tool. In order to do this, push the brush roller in from the side and lock it again, using a
coin to apply a little pressure.
7. Switch the device on.
Troubleshooting
Troubleshooting by yourself
So that as few problems as possible arise, it is important to empty the dust container regularly and to take this opportunity to
check/clean the motor protection lter.
Problem Possible cause / solution
Appliance cannot b e
switched on. The rechargeable battery is completely discharged. Switch off the appliance and charge the
rechargeable battery, chapter “Charging the rechargeable battery”.
The appliance cannot
be charged (LEDs do not
ash).
The mains adapter is not plugged in correctly. Check whether the mains
adapter’s connector and the mains adapter are connected rmly to their sockets, chapter
“Charging the rechargeable battery”.
The rechargeable battery has not been inserted correctly. Disconnect the
mains adapter. Check that the rechargeable battery is seated correctly in the appliance.
Connect the mains adapter again.
The appliance hardly
picks up any dust. The dust container needs to be emptied or the motor protection lter and the
dust container need to be cleaned, chapter “Maintaining the appliance”.
Operating duration is
becoming progressively
shorter.
The brush roller is soiled and needs to be cleaned, chapter “Cleaning the brush roller”.